How To Replace Headlight Bulb 2015 Chevy Equinox. For the equinox, gain access to the back of the headlight housing through the wheel well, then remove the dust cap over the bulb. Replace the low beam bulb's black plastic dust cap by rotating it 1/4 turn clockwise.
Replacing the bulb will restore functionality to both. When you change the headlight on your equinox, it is important to not touch the glass part of the bulb with your fingers because the oil from your fingertips will cause that part of the bulb to burn hotter, which significantly shortens the life of the bulb. Put the bulb back into the headlight, turning the retaining light clockwise until it locks into place, and replace the headlight assembly.
Table of Contents
Easiest Way To Replace The Headlight Bulbs (Same For Fog Lights) On Your 2010 Through 2015 Chevy Equinox.*I'll Also Show The Gasket/Seal Issue That's An Easy.
On average, the cost for a chevrolet equinox headlight bulb replacement is $107 with $12 for parts and $95 for labor. We just removed this headlamp assembly, did the same thing to the other side, but i just want to show you a comparison between headlamps. Prices may vary depending on your location.
For The Equinox, Gain Access To The Back Of The Headlight Housing Through The Wheel Well, Then Remove The Dust Cap Over The Bulb.
Sounds like you are right own.to change each bulb.you need to remove the chrome grill from the front center.be sure to pry up the clips carefully so not to break the trim bar.then each headlight assembly is removable with 3 10 mm bolts.do not touch your exposed fingers on the new bulbs.yes the low/high bulb is one unit.that is why i believe it is just your. If your equinox has this type of bulb, we do not recommend that you attempt to change it yourself. I'll explain and do my best to show you how to replace the headlight bulb in your 2015 chevy eqinox.
I Have A 2015 Ltz And I Would Like To Replace The Stock Lowbeam Bulbs With Zxe's.
Chevy equinox 2015, vision headlight replacement bulbs by philips®. Turn the retaining ring counterclockwise and pull the bulb out. It's a simple process that takes only a few minutes per light.
Push The Bulb Back Into Place And Replace The Ring;
The first one took maybe 15 minutes to remove the liner, 5 to safely remove and install the new bulb, and maybe 5 minutes to reinstall the fender liner. Be careful not to touch the glass part of the new highbeam bulb with your finger when changing it. Be careful not to touch the glass part of the new highbeam bulb with your finger when changing it.
Remove The Wiring Harness From The Bulb And Put The New Bulb In Its Place.
I probably spent 10 minutes washing and drying the fender liners. Be sure you're placing the right bulb in the right locations. Low beams are on the outside edge of the headlight assembly, and high beams are on the inside.